1. The power design should be reasonable and not exceed the standard. The normal power of each meter heating pipe is 3KW, which is easy to scale or dirty water power should be designed to be smaller.
2. Var uppmärksam på installationsriktningen vid installation
When installing from the side of the box, pay attention to the length of the outer pipe to make a cold area. We know that the water volume of the outer pipe part is relatively small and the heat flow is slow. Make a cold zone in case the heat can't be absorbed in time and burn out the heating tube.
När du installerar från toppen av lådan och nedåt, var uppmärksam på delen ovan som inte kommer i kontakt med vatten och gör den till en icke-uppvärmningszon.
3. Materialvalet bör vara rimligt
If the heated water is hard, it is easy to form scale, so not only to reduce the power but also use corrosion resistant pipe material. Lime scale, commonly known as calcium carbonate, is corrosive.
